FWD造句

1、FWD Apply to Detect Bridge Damage;

2、In addition, the advantage of FWD deflection bowel and FWD application in pavement design and evaluation are illustrated by examples.

3、Abstract: Based on research and application of FWD in roads, the author analyzes and presents seven practical techniques of FWD.

4、The WS-Routing intermediary should inspect the FWD element for via elements.

5、Study of the Pavement Modulus Back-Anaslsis Using the Datebase of FWD;

6、It is, essentially a FWD car platform rather than a body-on-frame RWD truck platform.

7、并列举了应用FWD测量路表弯沉盆的优点及FWD在道路设计与评价中的一些基本用途。

8、If a FWD element that contains one or more via elements is present, the receiver should remove and inspect the top via subelement of FWD and verify that it is the intended recipient of the message.

9、It was found that the deflection values measured respectively by FWD and BB were in good regressive relationship.

10、Attention! The 4-wheel drive(FWD) together with the1st gear start is the prerequisite during the plane traction.

11、FWD describes the forward message path and rev describes the reverse message path; the latter is optional.

12、When it comes to fuel economy, the V6 compromises little, managing 19/27 mpg in FWD trim and 19/26 in AWD guise.

13、Make it short and relevant and try to remove re: and FWD: they just get in the way of the message.

14、V6前驱版（FWD）和全时四驱版（AWD）燃油经济*分别为19/27mpg和19/26mpg。

15、参照国内外有关资料，建立了以FWD弯沉为基础的力学经验罩面设计方法。

16、So the correlations of PFWD and bearing plate, CBR, deflection, FWD are established according to many testing results. The analyses indicate that the correlations are good in double logarithm.

17、This receiver will become the ultimate destination when (1) there are no via elements listed in the FWD element after the removal of the top via element, and (2) there is no to element.

18、Designed to compete with Germany's highly efficient four-cylinder diesel lineup, the new car will be a compact hatchback with FWD and be priced cheaper than the current Lexus IS 220d.

19、为此，根据大量的试验检测结果建立了PFWD与承载板、CBR、弯沉和FWD检测值之间的相关关系，结果表明各检测值之间存在良好的双对数关系。

20、采用轴对称动力有限元结合系统识别反分析理论进行路面模量反算，考虑了落锤式弯沉仪（FWD）荷载作用下的路面反应动力效应。