oxide film造句

powdery oxide film

superconducting oxide film

The effect of microarc oxide film on titanium-ceramic bonding

Nanoparticle and nanolayer in oxide film and substantial Ge segregation;

Study on improvement of electrochromic properties of tungstic oxide film by PVA-doping

If the oxide film is hard, sliding occurs on the outside thereof.

Objectives: To study the oxide film of pure titanium implant material treated by anodic oxidation .

Formation of Al_2O_3-ZaO_2 composite anodic oxide film on aluminum foil

The new applications of porous anodic oxide film on aluminum are reviewed and technology of separating the film from aluminum substrate is described.

A new green sealing process of anodic oxide film of aluminum alloy was studied in this paper.

The key of the manufacturing process of anodic oxide film of aluminium wire is the continuous anodic oxidation.

The design principles of indium tin oxide film(ITO) to prevent lectrostatic discharge for optical solar reflector(OSR) are studied.

SEM and EPM results indicate that cracks form at edges and corners of LY12 aluminum alloy's oxide film.

For thin oxide films, the products of sealing reaction which takes place throughout the film, gradually fill all the pores. For thick oxide films, sealing reaction mainly occurs at the outer layer...

Results indicated that wear resistance and corrosion resistance of black TiN coating were higher than that of black oxide film or phosphatizing films.

The slightly porous nature of the surface of the oxide film allows it to be colored with either organic or inorganic dyes.

This indicates that the problem probably lies in a thin oxide film that forms on contacts and breaks down whenever moved.

The main defects of laser spot welding of aluminum are crater, hot crack and porosity which created by oxide film and keyhole instability,.

However, the excessive refinement of grains resulted in the growth stress increase of the oxides film and then the oxide films cracked and shed; as a result, the oxidation was exacerbated.

It was indicated that the linear defect appeared after machining is not crack, it is the appearance of oxide film involved in the casting under the effect of external force.

Therefore, formation of high valance vanadium oxide films was obtained.

Study of photoluminescence propertiesin Nd-doped-Si-based oxide films;