resistor造句

load limiting resistor

resistor-capacitor-transistor logic

resistor transistor logic

rocking resistor furnace

carbon film rotary variable resistor

Features: Built-in resistor at B-E, high voltage.

Precise resistor: Using 5 color bars to represent resistor value, the first 3 bars refer to base, the 4th bar is times, the 5th bar is error value.

A resistor is any device that, when you pass current through it, creates a voltage.

All the LEDs are connected in parallel with a 100-ohm resistor in series with each.

Its stable and even discharge makes the ballast resistor smaller which reduces extra power consumption.

Adding a current limiting resistor or fuse in series with each switch will help prevent this type of damage.

Preparation of thermal sensitive thin film resistor is one of key technologies in uncooled micro bolometer IR FPA fabrication.

The LC circuit has a certain parallel resistance R P , this is not a real resistor, but a virtual resistor caused by the losses in coil and tuner capacitor.

This paper analyzes the error of torque sensor of strain-resistor which derives from the influences of bending moment on elastic axis, and discusses the Eliminating techniques.

Figure 2-24 shows a protection circuit for an electrometer ammeter or picoammeter, consisting of a resistor and two diodes (1n3595).

The infection of the dimension of microstrip line to power capability of devices and the power capability of isolate resistor has been investigated in detail.

The active filter acts as an infinite impedance to the external for the fundamental frequency and as a low resistor for harmonic frequencies.

Only one high-quality resistor in the signal path and using the Swiss made precision attenuator with gold contacts for low contact resistance and longtime durability.

In a circuit diagram, on the other hand, a resistor might be oriented horizontally or vertically, and it might appear above, below, or next to the preceding circuit element.

The characteristics of the RS-11 type carbon resistor were measured using the above-mentioned cryostat. The results indicate that it can be used as a thermometer at ultra-low temperatures.

The operation of the SCCL involves two current transferring processes, i. e. the fast switch transfers the short circuit current to the GTO and then the GTO to the limiting resistor.

If the load resistor was connected directly across the voltmeter input terminals, the current through the relay contacts would cause a voltage drop and the measured cell voltage would be in error.