diaphragm valve造句

Pneumatic Angle. Vent valve, filter, the drain valve, the valve, the diaphragm valve, cock, piston valve, valve, valve, copper heat water valves, balance valve, trap, solenoid valves.

They are the pressure seal valve, the packed valve, and the diaphragm valve.

Optimizing the configuration of the diaphragm valve film by ANSYS

Relative to the developed countries, China's pneumatic diaphragm valve valve industry is still lag behind.

Sanitary diaphragm valve polishing reach 304,316 stainless steel material of the health standard as a body, as food silicone rubber or PTFE sealing diaphragm valve.

Fuel valve, a high-performance "gasoline switch", is widely used in developed countries. It is called vacuum diaphragm valve or vacuum diaphragm type "gasoline switch "in China.

At present, the development and production of the main products are butterfly valve, check valve, gate valve, ball valve, strainer valve, globe valve, slurry valve, diaphragm valves and so on.

Operating Principle: The tied-diaphragm valve is a handwheel-operated valve, utilizing a two-piece stem connected through the diaphragms.

According to structural characteristics of a flapper valve, flapper valves, butterfly valves, ball valves, diaphragm valves, Angle valves, through the valve, three-way valve.

Operating Principle: The diaphragm valve is a handwheel-operated valve, utilizing a two-piece stem separated by non perforated diaphragms. These diaphragms prevent leakage along the valve stem .

This control valve is a weir diaphragm valve and has created a clogging congestion point in the flow system that requires constant maintenance.

Sanitary pump is single stage, single suction, full closed stainless steel centrifugal pump or pneumatic diaphragm valve.

Rubber lined diaphragm surface of the body cavity lined or covered with a choice of a variety of rubber, dedicated to the diaphragm valve control non-corrosive or corrosive media.

The heat-resisting bellows diaphragm valve has the advantages of wide applicable temperature range, high fatigue resistance and long service life.

When disconnecting cylinders with diaphragm valves, it is most important to double close the valve and to properly install the outlet seal.

The standard applies to gate valves, globe valves, throttle valves and diaphragm valves such as valve connections on the drive size.

When opening a diaphragm valve , you will feel resistance for approximately one turn , at which point most or all resistance on the handwheel will disappear .

Note:1. Pneumatic diaphragm valve also can be installed feedback signal, limited machine or localizer in order to adapt to the requirements of automatic, programed control or flow rate adjustment.

According to characteristics of chemical industry process of production, this paper details the pneumatic diaphragm valve, s choice on type, acting mode, specific property of flow and diameter size.